8
ENGLISH
HOW TO ASSEMBLE
Assemble completely and charge batteries for 14-16
hours before using.
CAUTION: Use only Eureka model UA100025b charger.
Have a screwdriver available for assembly (not included).
Attach Handle Grip
Step 1: Locate the 2-part bolt
Step 2: Align the handle grip and handle tube holes and
secure with the 2-part bolt
Note: The single hole in the handle tube faces
forward in relation to the handle grip.
Attach Handle
(Fig. 2)
Step 1: Use your thumb to pull back on the lock button
Step 2: Push handle
G
AA
Step 3: Release lock button
it locks into place.
Secure Wall Bracket on Wall
Have a 1/4 inch drill available for assembly (not included).
Cleaner hangs in bracket with the nozzle end down. Mount
on a wall in close proximity to an electrical outlet where
there are not dangerous objects hidden beneath the wall
surface like electrical wires, pipes, etc. Leave 14 inches
above the floor for clearance.
Step 1: Hold bracket
I
AA
screws. Make sure the wall bracket is positioned
vertically, with the charger socket at the bottom.
Step 2: Use a 1/4 inch drill for drilling holes for the plastic
anchors
N
.
AA
Step 3: Insert the anchors
into both holes.
Step 4: Tighten the screws
Step 5: Place cleaner, with the nozzle pointed down, on
the wall bracket
Step 6: Plug the charger
Note: This charger has been designed to use as either
a wall mounted charger or to sit on a counter
or shelf
. To use on a counter or shelf, locate
P
AA
next to an electrical outlet. Take the battery
out of the cleaner and put in the counter bracket
I
. The charge light
AA
the battery is charging (Fig. 4).
(CONTINUED)
(Fig. 1)
in the assembly package.
H
AA
H
. Tighten the bolt
AA
into top of cleaner.
M
and rotate handle
AA
(Fig. 3)
against wall to mark location for
and drive the screws
N
AA
O
to secure the bracket
AA
I
.
AA
L
into an electrical outlet.
AA
J
or
K
will indicate that
AA
AA
M
.
AA
G
until
AA
O
AA
.
I
AA
C
AA