Protecting The Environment - Stanley SCD12 Manual De Instrucciones

the tool. These chemicals may weaken the materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Charger cleaning instructions
Warning! Shock hazard. Disconnect the charger from
the AC outlet before cleaning. Dirt and grease may be
removed from the exterior of the charger using a cloth or
soft non-metallic brush. Do not use water or any cleaning
solutions.
¡Important!To ensure
RELIABILITY, repairs, maintenance and adjustment (other
than those listed in thismanual) should be performed by
authorized service centers or other qualified organizations,
always-using identicalreplacement parts. Unit contains no
user serviceable parts inside.
ACCESSORIES
The performance of any power tool is dependent upon the
accessory used. STANLEY accessories are engineered to
high quality standards and are designed to enhance the
performance of power tool. By using STANLEY accessories
will ensure that you get the very best from your STANLEY
tool. STANLEY offers a large selection of accessories
available at our local dealer or authorized service center
at extracost.
Note: Accessory must be rated for use at speed equal
to or higher than nameplate RPM of tool with which it is
beingused.
Caution! The use of any non-recommended accesories
may be hazardous.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Stnley product
needs replacement, or if it is of no further use
to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
product SAFETY and
Batteries
This long life battery pack must be recharged
when it fails to produce sufficient power on jobs
which were easily done before.
At the end of its technical life, discard it with due
care for our environment:
f Run the battery pack down completely, then remove it
from the tool.
f Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will
be recycled or disposed of properly.
SERVICE INFORMATION
STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service Centers
are staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical
advice, repair, or genuine factory replacement parts, contact
the STANLEY location nearest you.
ENGLISH (
Original Instructions)
31