Protecting The Environment; Technical Data - Stanley FATMAX FMEH850 Manual Del Usuario

Ocultar thumbs Ver también para FATMAX FMEH850:

Manual de instrucciones (68 páginas)

Contenido

página de 61

/ 61
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

ENGLISH

Set the depth gauge (not supplied) to the desired position.

The maximum drilling depth is equal to the distance

between the tip of the drill bit and the front end of the

depth gauge.

Tighten the side handle by turning the grip clockwise.

Fitting an accessory (fig. B)

Open the chuck by turning the sleeve (6) counterclock-

wise.

Insert the bit shaft (9) into the chuck.

Tighten the chuck by turning the sleeve clockwise.

Use

Warning! Let the tool work at its own pace. Do not overload.

Warning! Before drilling into walls, floors or ceilings, check for

the location of wiring and pipes.

Switching on and off (fig. C, D)

Select the required speed by turning the speed selector

dial (5) as shown in figure C.

To switch the tool on, press the variable speed switch (1).

The tool speed depends on how far you press the switch.

For continuous operation, press the lock-on button (2) and

release the variable speed switch. This option does not

work in reverse rotation.

To switch the tool off, release the variable speed switch.

To switch the tool off when in continuous operation, press

the variable speed switch once more and release it.

Selecting the direction of rotation (fig. E)

For drilling and tightening screws, use forward

(clockwise)

rotation. For loosening screws or removing a

jammed drill bit,

use reverse (counterclockwise) rotation.

To select forward rotation, push the forward/reverse slider

(3) to the left.

To select reverse rotation, push the forward/reverse slider

to the right.

Warning! Never change the direction of rotation while the

motor is running.

Selecting the drilling mode (fig. F)

For Impact drilling in masonry and concrete, set the

drilling mode selector (4) to the

For drilling in steel, wood and plastics or for screw driving

set the operating mode selector (4) to the

Accessories

The performance of your tool depends on the accessory used.

Stanley Fat Max accessories are engineered to high quality

standards and designed to enhance the performance of your

(Original instructions)

position.

tool. By using these accessories you will get the very best

from your tool.

Maintenance

Your Stanley Fat Max corded/cordless appliance/tool has

been designed to operate over a long period of time with a

minimum of maintenance. Continuous satisfactory operation

depends upon proper tool care and regular cleaning.

Switch off and unplug the appliance/tool.

Or switch off and remove the battery from the appliance/

tool if the appliance/tool has a separate battery pack.

Or run the battery down completely if it is integral and then

switch off.

Unplug the charger before cleaning it. Your charger does

not require any maintenance apart from regular cleaning.

Regularly clean the ventilation slots in your appliance/tool/

charger using a soft brush or dry cloth.

Regularly clean the motor housing using a damp cloth. Do

not use any abrasive or solvent-based cleaner.

Regularly open the chuck and tap it to remove any dust

from the interior (when fitted).

Mains plug replacement (U.K. & Ireland only)

If a new mains plug needs to be fitted:

Safely dispose of the old plug.

Connect the brown lead to the live terminal in the new

plug.

Connect the blue lead to the neutral terminal.

Warning! No connection is to be made to the earth terminal.

Follow the fitting instructions supplied with good quality plugs.

Recommended fuse: 5 A.