Haier HFH-50 Manual De Instrucciones página 13

English
The user instructions apply to several models, for
this reason there may be some differences
the details given, according to the type of the appliance..
1 Protecting the environment / advice for disposal
Packing
serves to protect the appliance during transportation and
recyclable materials have been used for packaging.
Corrugated board/cardboard (mainly from waste paper).
- shaped parts in PS (foamed CFC- free polystyrene)
- foils and bags in PE (polyethylene)
- strapping tapes in PP (polypropylene)
- Please hand over all packaging to the nearest official
collection point, so that all the different materials can
be re-used or recycled as far as possible and
any illegal depositing of such materials is thus avoided
2 Deciding where to locate your appliance
In order to avoid any damage or injury to
persons or things, the appliance should be unpacked
by two people and placed in the chosen location
Before positioning it, check that your new appliance
has no visible outer damage.
On no account should you start up your appliance if it is
damaged. Check the appliance carefully for:
■ Damage to the packaging which might indicate that
appliance has been mishandled during transportation
■ Damage to the outer casing
■ Any visible damage to the cable / plug
If in any doubt
department
check the appliance.
It must at all costs be avoided, that any environmentally
damaging refrigerant
appliance.
3 Installing your appliance
a) Unpack the fridge / freezer.
b) Remove any objects from inside the appliance
c) Carefully remove all film and adhesive tape from the
casing from the door
d) Remove any
around the compressor (if present).
e) Remove all documents
inside the appliance.
f) Clean the inside
lukewarm water
thoroughly with a soft cloth.
let the customer service
leaks out by starting up the
polystyrene pieces
and accessories
of the appliance
and vinegar and
in
Do not
abrasive household
cleaning
■ Make sure that the pipes for the circulation of the
refrigerant
installation of the appliance.
■ The appliance must only be used for the purpose
for which it is intended.
■ The appliance. must
level surface.
that the refrigerant
ensure that your appliance will work effciently.
■ If possible,
well aired, dry room.
■ Do not place your appliance in direct sunlight, nor in a
room at high temperature.
■ Do not
of any sources of direct heat such as heating, ovens,
cooking stove
compressor would have
a result
considerably higher).
If installation
cannot be
suitable insulation plate between the appliance and
the heat source (do not use asbestos), or at least
the following minimum distances must be observed:
■ from a gas or electric cooker
■ from a radiator or oven etc
■ from another refrigerating appliance
Do not place any appliances, such as microwaves,
toasters etc. which give off heat on the
appliance
Never obstruct the ventilation grille.
Always pull out the plug itself and never pull the
cable when cutting the appliance off from the mains
supply.
WARNING !
Leave the appliance standing in its final position for
at least 2 hours before switching it on, so that the
circulation
no operating problems occur.
Before connecting up the appliance, make sure that it
is absolutely dry inside - especially in the corners..
from
Danger warnings
from
Depending on its composition, the
be easily
with
has been hermetically sealed
dry it
many times for possible leaks. Any inexpert interference
might well
mechanically effects the circulation of the refrigerant,
nor, in particular,
compressor..
Only expert professional personnel should intervene
on the refrigerating system.
2
Instruction for use
use washing liquids,
products
agents containing soda.
are not damaged in any way during
be placed
This is the only
can circulate
place your appliance
place your appliance
etc. (This would
to work
the power consumption would be
near a direct heat
avoided, we recommend fitting a
of the refrigerant
inflammable. The
and has been
create a fire hazard.
the accessible
Freezer
sharp or
or any other
on a firm,
way to ensure
freely and thus
in a cool,
in the vicinity
mean the
harder and as
source
.
30cm
30 cm
30 cm
stabilises and
refrigerant can
refrigerant circuit
tested
Make sure nothing
parts around the