Flip Back Height Adjustable T-Arm - Ki Mobility Catalyst 5Vx Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
E. Flip Back Height Adjustable T-Arm
Use
1. To flip back the armrest, pull the release lever (Fig. 4:A) up and lift the armrest assembly up and
back.
2. To return the armrest down, lower the armrest assembly until the release lever locks back into
place.
Fig. 4
To Increase/Decrease the Front End Length of Armrest
1. Pull the height adjustment lever (Fig. 5:A) and remove the upper
T-Arm assembly (Fig. 5:B).
2. Rotate the upper T-Arm assembly and reinstall into the armrest.
3. Close the height adjustment lever (Fig. 5:A) to secure.
NOTE: The armrest pad is not centered on the tube, widthwise
or lengthwise. This offers two different length options - longer or
shorter on the front end of the chair. This also offers two options
with the armrest pad. When the long end of the armrest is on the
front end of chair, the amrest pad hangs more to the outside of
the chair. The armrest pad hangs more to the inside of the chair
when the short end of pad is on the front end of chair. The
armrests can also be switched to the opposite sides to allow
more options regarding the amount of front end pad length and
side pad length.
To Increase/Decrease the Height of the Armrest
1. Pull the height adjustment lever (Fig. 6:A) and slide the
upper T-Arm assembly to desired height.
NOTE: Each hole on the upper T-Arm assembly bar
represents a height setting that can be used in ½" (1.27
cm) increments.
2. Close the height adjustment lever (Fig. 6:A) to secure.
A
Loosen or tighten this screw to
decrease or increase tension
when flipping armrest assembly.
18
A
Fig. 5
Fig. 6
A
B