IVT PRINETO Manual De Instrucciones página 35

4.5.2 Configuration with room control unit Wireless Display (continued)
No. Parameters
040 External sensor connected to
the RBG
060 Correction of actual value
registration
110 Control direction
switching outputs
115 Use as setback input
120 Unit of temperature display
Pump configuration
130 Pump output
131 Pump type
132 Pump line-up time
133 Pump follow-up time
134 Control direction switching
output
135 Minimum running time
136 Minimum standstill time
Configuration of change-over functionality / boiler relay
140 Function of relay boiler / CO
output
141 Line-up time
142 Follow-up time
143 Control direction switching
outputs
160 Antifreeze protection
161 Antifreeze temperature
170 Smart Start
Description
Logging on an additional sensor for the registration of the
floor temperature (FBH), the room temperature or the dew
point
Registration of the actual temperature with a correction factor -2.0...+2.0 K
Switchover of NC and NO actuators (only globally)
Change-over between use of the ECO input for setback or
holiday function of the room control unit.
The holiday function cannot be activated any longer via the
room control unit if this parameter has been set to 1.
Toggle function of the display between degree Celsius and
degree Fahrenheit
Use the control of a local recirculation pump (in the heating
circuit distributor) or a global recirculation pump (heating
installation).
Selection of the used pump: Conventional Pump (KP) / High
efficiency Pump (HP)
Time elapsing from the moment of the command from a
switching output until the pump is actually switched on.
Time elapsing from the moment of switching off the switching
outputs until the pump is actually switched off.
The control direction can be inverted if the pump relay is used
as control output
The minimum running time indicates how long the HP must run
until it may be switched off again.
High efficiency pump: The pump may only be switched off if
a minimum standstill time can be ensured.
Selection whether the switching output shall serve for control-
ling a pump relay, or as CO pilot
Boiler relay line-up time for conventional pump
Boiler relay follow-up time for conventional pump
The relay function can be inverted if used as a control output.
Activation of control outputs for T
Antifreeze function limit value
Learning-in of the temperature behaviour of the individual
heating zones
<x °C
actual
Unit
no sensor=0
Dew point sen.=1
Temp FBH=2
Temp room=3
in 0.1 increments
NC=0 / NO=1
ECO=0
Holiday=1
°C=0
°F=1
local=0
global=1
CP=0
HP=1
[min]
[min]
normal=0
inverted=1
[min]
[min]
Boiler=0
CO pilot=1
[min]
[min]
normal=0
inverted=1
Deactivated=0
Activated=1
[°C]
Deactivated=0
Activated=1
35
DEU
ENG
FRA
NDL
ITA
ESP