Safety Information - Cadac CARRI CHEF 2 8910 Manual Del Usuario

3. Safety Information

Hose
This appliance may only be used outdoors.
•
• A hose and regulator is supplied with this appliance (South Africa Only)
• The hose must be checked for wear or damage before every use and before connecting to the gas
container.
• Do not use the appliance if it has a damaged or worn hose. Replace the hose.
• Do not use the appliance if it is leaking, damaged or which does not operate properly.
Gas Container
• Only use a cylinder that is approved by your countries regulations.
• Ensure that the gas container is fitted or changed in a well-ventilated location, preferably
outdoors, away from any sources of ignition such as naked flames, pilots, electric fires and away
from other people.
• Keep gas containers away from heat and flame. Do not place on a stove or any other hot surface.
• Gas cartridges/refillable cylinders are to be used only in the upright position so as to ensure proper
fuel withdrawal. Failure to adhere to this may cause liquid discharge from the gas container
resulting in a dangerous operating condition.
• Do not try to remove the cylinder whilst the unit is in operation.
• A space has been provided in the centre of the utility tray to place a gas cartridge into.
• The gas cylinder must be disconnected from the appliance after use or when in storage.
Assembly and use
• The appliance is designed to be portable, therefore the legs and the utility tray is easily removable
/ assembled the ease of transport and use.
• User assembly / dis-assembly is limited to the fitment of the legs, utility tray, and the installation /
removal of cooking surfaces.
• When assembling the legs, always make sure that the leg securing rings have been securely
fastened and that the assembled product is stable and does not rock. Do not use the appliance
without fitting the accessories tray as it also plays an important role in ensuring the overall
sturdiness of the appliance.
• Use only on a firm level surface.
• Do not move the appliance whilst the unit is in operation.
• Should the heat shield, fat pan or burner pan become damaged in such a way that permanent
contact between the heat shield and the fat pan occurs during use, do not use the appliance.
Return it to your Cadac stockist for repair.
• Do not cover up or change the air holes in the valve box cover as this will affect the performance
of the product and may lead to an unstable flame.
• Ensure the appliance is used away from flammable materials. Minimum safe distances are: Above
the appliance 1.2m. At the rear and sides 600mm. (See Fig. 2)
• Caution: When using the appliance, we recommend the use of protective gloves when removing
and applying the dome, as the dome handle may become hot.
Caution: Accessible parts may become very hot, the use of protective gloves is recommended.
•
• Keep young children away from the appliance.
• Use Outdoors Only
• NOTE! If the appliance is used in windy conditions, the dome must be used as a wind shield, and
placed in position (as shown in Fig. 4).
Light back
• In the event of light back (where the flame burns back and ignites inside the burner or venturi
housing), immediately turn off the gas supply by firstly closing the control valve on the gas
container and then the appliance valve. After the flame is extinguished, remove the regulator and
check the condition of the seal; replace the seal if in doubt. Re-light the appliance as described
in section 6 below. Should the flame persistently light back, return the product to your authorised
CADAC repair agent.
Leaks
• If there is a leak on your appliance (smell of gas), immediately close the control knob on the gas
cylinder. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks
using a flame; use soapy water.
• The correct way is to smear the joints with soapy water. If a bubble or bubbles form then there
is a gas leak. Immediately turn off the gas supply firstly by closing the control valve on the
gas container and then the appliance valve. Check that all the connections are properly fitted.
Re-check with soapy water. If a gas leak persists, return the product to your CADAC dealer for
inspection / repair.
• Check for leaks on the tailpiece by the valve and on the cylinder regulator fitting with gas open on
cylinder but not open or switched on by the appliance control knob.
2 2
Only applicable to
8910-10, 8910-20,
8910-30, 8910-40,
8910-50, 8910-70
& 8910-80
GB
Fig. 1
Fig. 2
Fig. 3
WIND
Fig . 4