Pioneer AVH-5200DVD Manual De Instalación página 5

Connecting the units
80 cm
26 pin cable (Supplied with Navigation unit)
Insert the 26 pin cable in the direction
indicated in the figure.
Fuse resistor
Connection method
Note:
· The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle
Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of
the parking brake switch.
Blue/white
Connect to system control
terminal of the power amp
(max. 300 mA 12 V DC).
Blue/white (5*)
The pin position of the ISO
connector will differ depending on
the type of vehicle. Connect 5* and
6* when Pin 5 is an antenna control
type. In another type of vehicle,
never connect 5* and 6*.
Tuner box (supplied)
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear shift is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
1. Clamp the lead.
Power supply side
Ground side
Blue/white (6*)
Connect to auto-antenna relay control
terminal (max. 300 mA 12 V DC).
Notes:
· Change the initial setting of this unit (refer to the Operation Manual). The
subwoofer output of this unit is monaural.
· When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and
Violet/black leads of this unit. Do not connect anything to Green and
Green/black leads.
Antenna input
80 cm
Antenna cable (supplied)
Navigation unit
(AVIC-F220 (sold
separately)).
Please contact your dealer to inquire
about the connectable navigation unit.
2. Clamp firmly with
needle-nosed pliers.
Parking brake
switch