Inserting/Changing The Batteries - Bosch GPL100-30G Instrucciones De Funcionamiento Y Seguridad

Preparation

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to op-
erate the measuring tool.
If required, turn the magnetic rotating mount (3) to the side so that
the battery compartment cover (6) is not obstructed.
Press the locking mechanism (5) upwards to open the battery com-
partment cover (6) and remove the battery compartment cover. In-
sert the batteries.
When inserting the batteries, ensure that the polarity is correct ac-
cording to the illustration on the inside of the battery compartment.
Reattach the battery compartment cover (6) and press it firmly into
place at the marked point above the locking mechanism (5).
If the batteries are running low, the laser points will gradually be-
come dimmer.
If the batteries are almost empty, the laser points will flash for 5
times every minute.
If the batteries are empty, the laser points will flash once before the
measuring tool switches off.
Always replace all the batteries at the same time. Only use batter-
ies from the same manufacturer and which have the same capacity.
Take the batteries out of the measuring tool
when you are not using it for a prolonged pe-
riod of time. The batteries can corrode and self-discharge during
prolonged storage in the measuring tool.
-15-
GPL100-30G 50G 11-20.indd 15 4/23/21 5:27 PM