Inserting/Changing The Batteries - Bosch Quigo Plus Manual Original

Cross line laser
Operating time, approx.
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions
(e.g. direct sunlight).
B) At 20–25 °C
C) The values stated presuppose normal to favourable environmental conditions
(e.g. no vibration, no fog, no smoke, no direct sunlight). Extreme fluctuations in
temperature can cause deviations in accuracy.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity
caused by condensation is expected.
The serial number (8) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to operate the
measuring tool.
Push the locking mechanism (4) in the direction of the arrow to open the
battery compartment cover (6) and remove the battery compartment cover.
Insert the batteries supplied.
When inserting the batteries, ensure that the polarity is correct according to
the illustration on the inside of the battery compartment.
If the batteries become weak, the laser lines will flash quickly for a few
seconds.
Always replace all the batteries at the same time. Only use batteries from the
same manufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it
u
for a prolonged period of time. The batteries can corrode and self-dis-
charge during prolonged storage in the measuring tool.
Bosch Power Tools
B)
English | 19
Quigo Plus
> 5 h
0.27 kg
65 × 65 × 65 mm
1 609 92A 7SA | (09.09.2022)