Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Modifying the program:
1. Switch on the circuit breaker (C) in the left side of the furnace.
2. Turn the knob (H) clockwise to switch on the control panel and modify the program.
3. Press the key. The upper display will show the
4. Select the first set-up temperature by pressing the keys (the key allows to move from units to
tens and to hundreds in order to modify their values more quickly). We recommend to select always 0 ºC
as initial temperature.
5. Press the key. The upper display will show the
6. Select the first time by pressing the keys.
7. Press the key. The upper display will show the
8. Proceed in the same way for all the steps.
9. If you want to finish a working cycle, select the "-121" for the last time-parameter.
10. If you want to move directly to a given step, first press the key; then select the step by pressing the
keys, and access the parameters with the key.
11. If you want to leave the programming, press the key and the key at the same time.
Observations:
▪
We recommend to use always the "0" value for C1.
If you want to maintain the same temperature for a while, select that temperature in the next step.
▪
If you want to finish a working cycle, select the "-121" negative value for the last time-parameter.
▪
When you modify the value of a parameter, the value is automatically stored in the memory.
▪
The value of the parameters can be modified even when the program is under way.
▪
▪
When selecting the time to reach a given temperature, select a time long enough to prevent the furnace
from working at full power when it is not necessary.
Do not program a time lower than 15 minutes from 0 to 200 ºC.
▪
ADVANCED PROGRAMMING
The electronic controls of the R-080110 allow to store different programs in the memory, one after the other,
and to use each one whenever it is needed.
To do this, insert the values of the different programs from Step 2 on, and finish each program with the "-121"
time value.
You can use the t01 value, with a negative sign, to select the step in which you want the furnace to start
working.
message.
message
message.
English
13
Publicidad
Tabla de contenido
