Innotek ULTRASMART IUC-4100E Manual Del Usuario página 4

INNOTEK
Quick Start Guide
Follow Page Numbers For Detailed Instructions
Step 1
Design Your Fence
Have the local utility companies mark your underground lines; in
most communities this is a free service. On a sheet of paper, sketch
your house and yard. Draw a line around your property that
represents the containment area for your dog, avoiding
underground utility lines. Where it is not possible to avoid utility
lines, run your wire perpendicular to the underground lines.
Step 2
Install the Wall-mount transmitter
Locate the transmitter indoors on an exterior wall near an AC power
outlet; inside a garage or basement is ideal. The containment twisted
wire will need to run from the transmitter and pass through a window
or small drilled hole to the outdoors.
Step 3
Lay Out the Fence Wire
Run the containment wire around the property as outlined in your plan. Use
gradual rounded corners with wide radiuses. Avoid sharp (90°) angles.
Step 4
Final Connections
Splice each end of your pet fencing loop wires to the twisted wire.You
must use the supplied waterproof splices. Connect the lead ends of
the twisted wire to the wall mount transmitter. Plug in the AC Adapter
and connect it to the transmitter. Turn the transmitter ON. The
transmitter's green light should illuminate, indicating a successful
continuous loop.
® UltraSmart In-ground Pet Fencing Systems
2
IUC-4100E & IUC-5100E
Boundary Wire
10'
90Þ
10'
Page 5
Page 6
Page 6
Boundary Wire
Splice
To wall-mount transmitter
Page 7