Placing Tool In Service - Ingersoll Rand 772 Instrucciones

LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C01–C2–T29
For USA – No. C08–02–FKG0–28
Before starting the new tool, pour about 1/2 teaspoon
(1.5 cc) of Ingersoll–Rand No. 10 Oil into the air inlet of
the tool and attach the air hose. Insert a Chisel into the
tool and, with the Chisel held firmly against some
relatively solid object, operate the tool momentarily so
that the oil reaches all working parts.
After each two or three hours of operation, unless the
air line lubricator is used, detach the air hose and pour
three or four drops of Ingersoll–Rand No. 10 Oil into the
air inlet.
Model Type of
Handle
772 Pistol Grip
H
Tested in accordance with PNEUROP PN8NTC1.2 under load
♦ Tested in accordance with ISO8662–2

PLACING TOOL IN SERVICE

SPECIFICATIONS
Impacts/min. Piston Stroke
in
3 000 2–1/4
If the action of the tool becomes sluggish, remove the air
hose, pour about one teaspoon (3 cc) of a clean, suitable,
cleaning solution (never use lacquer thinner) into the air
inlet and operate the tool no longer than thirty seconds.
Immediately after cleaning, pour about 1/2 teaspoon
(1.5 cc) of Ingersoll–Rand No. 10 Oil into the air inlet of
the tool and operate momentarily so that the oil reaches all
working parts.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
mm Pressure
57 98.3
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
dB (A) Level
Power m/s
111.3 10.8
2