Unpacking The Refrigerator; Choosing The Proper Location - LG GS73SXS Manual Del Propietário

Ocultar thumbs Ver también para GS73SXS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12 INSTALLATION

Unpacking the Refrigerator

WARNING
x Use two or more people to move and install the
refrigerator. Failure to do so can result in back
injury or other injury.
x 7KH UHIULJHUDWRU LV KHDY\ 3URWHFW WKH ÀRRU ZKHQ
moving the refrigerator for cleaning or service.
Always pull the refrigerator straight out when
moving it. Do not wiggle or walk the refrigerator
ZKHQ WU\LQJ WR PRYH LW DV ÀRRU GDPDJH FRXOG
occur.
x .HHS ÀDPPDEOH PDWHULDOV DQG YDSRUV VXFK DV
gasoline, away from the refrigerator. Failure to
GR VR FDQ UHVXOW LQ ¿UH H[SORVLRQ RU GHDWK
NOTE
x Remove tape and any temporary labels from
your refrigerator before using. Do not remove any
warning labels, the model and serial number label,
or the Tech Sheet that is located under the front of
the refrigerator.
x To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can
also be easily removed by rubbing a small amount
of liquid dish soap over the adhesive with your
¿QJHUV :LSH ZLWK ZDUP ZDWHU DQG GU\
x Do not use sharp instruments, rubbing alcohol,
ÀDPPDEOH ÀXLGV RU DEUDVLYH FOHDQHUV WR UHPRYH
tape or glue. These products can damage the
surface of your refrigerator.
x Reinstall or adjust shelves as needed. Refrigerator
shelves are installed in the shipping position.
Reinstall shelves according to your individual
storage needs.
Choosing the Proper
Location
Water
Water supply must be easily connected for the
automatic icemaker.
NOTE
x The water pressure must be 20 - 120 psi or 138 -
827 kPa or 1.4 - 8.4 kgf/cm
installed in an area with low water pressure (below
20 psi or 138 kPa or 1.4 kgf/cm
booster pump to compensate for the low pressure.
Electricity
Use an individual, grounded outlet:115 Volts, 60 Hz,
AC, 15 Amps minimum.
WARNING
x Don't use existing holes unless they are in the
target area. Otherwise, the water supply and
drain hose may be damaged by being crushed
or kinked.
Flooring
To avoid noise and vibration, the unit must be
LQVWDOOHG DQG OHYHOHG RQ D VROLGO\ FRQVWUXFWHG ÀRRU ,I
required, adjust the leveling legs to compensate for
WKH XQHYHQQHVV RI WKH ÀRRU
NOTE
x Installing on carpeting, soft tile surfaces, a platform
or weakly supported structure is not recommended.
Ambient Temperature
Install this appliance in an area where the
temperature is between 55 °F (13 °C) and 110 °F
(43 °C).
If the temperature around the appliance is too low or
high, cooling ability may be adversely affected.
2
. If the refrigerator is
2
), you can install a

Hide quick links:

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido