16 INSTALLATION
4
Lift the door from the lower hinge pin.
Lower Hinge
CAUTION
x When lifting the hinge free of the latch, be careful
that the door does not fall forward.
x Place the door, inside facing up, on a
nonscratching surface.Be careful not to damage
the water lines.
NOTE
x Do not remove the grease on the surface of the
gasket or hinge.
x Do not remove the sensor assembly in the right
upper hinge cover.
Assembling the Freezer Door
1
Feed the water tubes through the lower hinge
pin and place the door onto the lower hinge pin.
Make sure the water hoses are behind the leg to
prevent damage.
NOTE
x Open the door and turn the hose toward the inside.
Water hoses should be behind the leg to prevent
damage.
Correct
Disassembling/Assembling the Water Lines
2
NOTE
x Water hoses should be cut with a clean, straight
edge to avoid leaks.
3
4
5
6
Incorrect
Collet
Tube
Insert line
Clip
Gently press the collet and insert the tube until
only one line shows on the tube.
Correct
Fit the top over the hinge lever latch and into
place. Rotate the lever clockwise to secure the
hinge.
Install the grounding screw and connect all the
wire harnesses.
Hook the tab on the door switch side of the cover,
under the edge of the wire opening in the cabinet
top. Position the cover into place. Insert and
tighten the cover screw.
Reconnect the water tubes by inserting the tubes
into the connectors. The tube is inserted correctly
when only one guide line is showing out of two.
(Correct)
Incorrect