Troubleshooting - Steamfast Sidekick SF-320 Manual Del Propietário

PROBLEM
Unit fails to heat up. Power
Indicator Light DOES NOT
illuminate when Steam Control
Dial is turned to "on" position.
Unit fails to heat up. Power
Indicator Light DOES illuminate
when STEAM CONTROL DIAL is
turned to "on" position.
NOTE: Always allow sufficient
time for unit to heat up before
pressing Steam Trigger.
Steam output is weak or
intermittent.
Accessories do not stay firmly
connected to Steam Nozzle / Jet
Nozzle.
12

Troubleshooting

POSSIBLE CAUSE
Unit is not plugged in.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Water Tank is empty.
Mineral build-up in unit.
Unit is damaged or otherwise in
need of repair.
Water level in Water Tank is
running low.
Mineral build-up in unit.
Accessories not properly installed.
SOLUTION
Plug power cord into electrical outlet.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 13 for details).
Refer to Filling Water Tank
procedure on Page 9.
Refer to Care & Maintenance
section on Page 11 for details.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 13 for details).
Refer to Filling Water Tank
procedure on Page 9.
Refer to Care & Maintenance
section on Page 11 for details.
Check to make sure that
accessories are properly connected,
per procedures on Pages 6-8.