Flask Press - Dreve Drufomat scan Instrucciones De Trabajo

10.2 Flask press

In combination with the optionally
available P insert the Drufomat scan
can also be used as flask press. One
or two flasks may be pressed at the
same time.
Turn on the unit, swivel out plate recep-
tion (11) and heating element com-
pletely (4) by means of the operating
knobs (10/5) and take the F insert (6)
out of the bottom plate. Insert the P
insert into the pressure chamber from
underneath.
For one flask: Put back the F insert (6)
into the bottom plate.
For two flasks: Remove nub plate and
insert bowl from F insert and insert them
into the bottom plate.
Place flasks onto the nub plate. By mov-
ing the piston with the P insert down-
wards the necessary pressure will be
exerted upon the flasks.
For this purpose go on as described in
point 8.4.
Info
In order to attain a homogeneous
distribution of the material to be
compressed in the flask we recom-
mend an initial pressure of 29 psi
(2 bars) which can be increased
step by step up to 87 psi (6 bars)
during the pressing procedure (see
point 8.2).
45 45