Publicidad
Idiomas disponibles
Idiomas disponibles
m CAUTION! Do not leave children unattended.
The product is not a climbing frame or toy. Make
sure that nobody climbs or leans on the product,
particularly children. The product could become
imbalanced and tip up. Risk of injury and / or
product damage.
m CAUTION! DANGER OF TIPPING
OVER! Ensure that the product stands in stable
equilibrium on a firm surface. The cantilever
parasol must always be used in conjunction with
4 pieces of approx. 50 x 50 x 5 cm paving
slabs with a minimum total weight of 90 kg (not
included). Otherwise the cantilever parasol could
tip over. Risk of injury and / or product damage.
Never move the cantilever parasol in the open
state. Always fully close the parasol top 8 first
and pull in the arm 7 completely. Otherwise the
load on the product could become unbalanced
and cause it to overturn. Risk of injury and / or
product damage.
m CAUTION! FIRE HAZARD! Never place
the product near an open fire and / or radiant
heaters.
Make sure that this product is standing on a
solid, level surface.
Make sure the product is stable before use!
m CAUTION! RISK OF INJURY! Before
opening and closing the product, make sure that
there are no people standing too near to it.
m CAUTION! RISK OF CRUSHING! Watch
your fingers when opening and closing the
product. If you are careless, you risk injuring your
fingers by crushing them!
10 GB/IE
Ensure that the top pole with attachments 6 is
attached firmly to the bottom pole section 3 on
the paving stand. Unless this is done, it is not safe
to use the cantilever parasol.
Close the cantilever parasol if the wind
shows signs of increasing in speed or
on the approach of squally showers.
Never use the product as protection against bad
weather.
Never leave an open cantilever parasol
unattended. Damage could occur if strong winds
arise unexpectedly.
Close the cantilever parasol in the event of wind,
snow or rain.
Do not hang any objects (e. g. clothing) from the
product.
˜ Assembly / disassembly
Note: For assembly you will need a working space
at least 16 m² in area and 4 m in diameter.
Note: If possible, have a second person help you
with the assembly.
˜ Assembling the paving stand
Fit the cross member for paving stand 2 2 on
top of the cross member for paving stand 1 1
(see Figure B).
Bolt the bottom pole section 3 to the assembled
cross members. Tighten the bolts (approx. M8 x
20 mm) 4 with the washers (approx. 8 mm) 5 ,
using a wrench (see Figure C).
Note: Keep 4 pieces of approx. 50 x 50 x
5 cm paving slabs with a minimum total weight of
90 kg close at hand for the paving stand.
Publicidad
