Power Source - Naxa NAS-5003 Manual De Instrucciones

POWER SOURCE:

There is a built in Li-ion rechargeable battery, recharge it if the battery is low.
1. Connect the Micro USB Plug from the supplied USB Connection Cable to the Micro
USB Port on the rear of unit.
2. Connect the full sized USB Plug from the supplied USB Connection Cable to the
USB Port on the USB Charger (During
unit will turn RED,
NOTES:
Your battery will last longer if you're following these simple guidelines for charging
and storing:
A. Before first time use, charge it approximately hours until the unit is fully charged.
B. Recharge and store the unit within the temperature range of 5°C~35°C
(40°F~95°F).
C. Do not charge longer than 24 hours. Excessive charging or running the
unit until battery fully drains will damage battery. Battery life will be extended
if you keep the battery fully charged.
D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product is not user replaceable.
AUX IN:
To listen from an external Audio Player such as a MP3 Player, Discman ...etc.
1. Connect one end of the Audio Connection Cable to the AUX Out/Line Out/Phone
Jack on the external Audio Player.
2. Connect the other end of the cable to the AUX IN Jack on the rear of the unit.
Press and hold the
blinks green only, press the
will turn INDIGO.
3. Play the music on the connected Player as usual.
charging, the charge indicator on the top of
When finished, it will turn off).
MODE button to power on the unit, wait the mode indicator
MODE button repeatedly until the Mode Indicator
8
4