Thermostat" Functional Block; Phe" Primary Plate Heat Exchanger Functional Block - TiSUN MULTIPLEX Advanced Manual Del Usuario

4.2

"Thermostat" functional block

Heating (if Start < Stop) and cooling (if Start > Stop)
Settings
Sensor (ON/OFF)
Off-Sensor (just OFF)
Start (output ON)
Stop (output OFF)
Timer (3x)
Delay
4.3

"PHE" primary plate heat exchanger functional block

Settings
Primary sensor (warm)
Secondary sensor (cold)
dT max (start)
dT min (stop)
Min. primary sensor
Max. secondary sensor
Timer (3x)
Delay
DUPLEX and MULTIPLEX Systems with Main Plate Heat Exchanger function
System 1 Mutiplex
P1= Dt(T1,T2)
1 x PHE = PX = Dt(Tx,T2)
Options
T1 to T12
no, T1 to T12
15 to 130 °C
0 to 140 °C
00.00-24.00
-900 to +900sec.
Options
Tx = T1 to T12
Tank sensor(s)
3 to 40 °C
2 to 30 °C
0 to 95 °C
15 to 95 °C
00.00-24.00
-900 to +900sec.
System 2 Mutiplex
P1= Dt(T1,T2orT4)
P2= Dt(T1,T4)
1 x PHE = PX = Dt(Tx,T2orT4)
Factory setting
Selectable
Optinal Thermostat function with 2
no
55 °C
65 °C
00.00-24.00
0sec. pre(- sec.) and after(+ sec.) output delay
Factory setting
Selectable Temperature sensor onplate heat exchanger
Of specified system
15 °C
7 °C
65 °C
15 °C
00.00-24.00
0sec. pre(- sec.) and after(+ sec.) output delay
System 3 Mutiplex
P1= Dt(Tx,T2)
P2= Dt(Tx,T4)
1 x PHE=PX=Dt(T1,T2orT4)
11
Note
Temperature Sensor PT1000
Sensor for tank loading (lower placed)
Start temperature
Stop temperature
3 time frames adjustable (see timer)
Note
Tank temperature sensor(s)
dT max
dT min
Minimum temperature for ON
Maximum tank temperature
3 time frames adjustable (see timer)
System 4
P1= Dt(T1orT4,T2)
P2= Dt(T4,T2)
1 x PHE = PX = Dt(Tx,T2)
nd
Off-
Mutiplex