Audio Level Adjustment; Onstar Level Adjustment; Manually Set The Radio Type - Axxess GMLAN11-100 Instrucciones De Instalación

audio level adjustment

1. Start your vehicle and turn on the radio having audio playing.
2.
Turn your aftermarket radio's volume up ¾ of the-way.
3.
With a small screwdriver adjust the potentiometer clockwise to raise the audio level
and counterclockwise to lower the audio level.
4.
Once at desired level your audio adjustment is complete.

onStar level adjustment

To adjust the OnStar volume level find the Black/Yellow wire on the 16-pin harness.
•
Push the blue OnStar button, while the voice is speaking tap the Black/Yellow wire
•
to ground.
Once the volume is set it will stay at that volume until the Black/Yellow wire is tapped
•
to ground again. This can be set during installation and then left alone.
• If user adjustment is desired, the customer may also tap volume up or down on the
steering wheel (if equipped) to adjust the OnStar level.
Manually Setting radio type:
If the LED flashes do not match the radio connected you must then manually program the
ASWC to tell it what radio it is supposed to be connected to.
To manually program the aftermarket radio:
1.
Turn on the ignition. Then press and hold the "Volume Down" button on the steering
wheel control until the LED goes solid red and then release the "Volume Up" button.
2.
Using the listing below press the "Volume Up" button the number of times (number is
to the left of the radio name) needed to program the correct radio type to the ASWC:
Continued on next page
GMLAN11-100
Programming SWC
1
Eclipse
2
Kenwood
3
Clarion "Type 1"
4
Sony/Dual
5 JVC
6
Jensen/Pioneer
7
Alpine
8
Visteon
9
Valor
10 Clarion "Type 2"
11 Metra OE
7