Kit Assembly - Metra 108-GM1G Instrucciones De Instalación

Note: For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the radio chassis brackets to the
radio chassis using (4) screws supplied
with the radio. (Figure A)
2. Secure the radio display to the radio
display brackets using (6) screws
supplied with the radio. (Figure B)
3. Secure the display/bracket assembly to
the radio trim panel using (4) Phillips
screws provided. (Figure C)
4. Clip the factory climate controls into the
radio trim panel. (Figure D)

KIT ASSEMBLY

(Figure A)
(Figure B)
(Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Complete
all connections to the radio and vehicle,
then test the radio and vehicle for
proper operation.
6. Slide the radio chassis into the dash and
secure using the factory screws.
(Figure E)
7. Secure the radio display and trim panel
assembly to the vehicle using the
factory screws. (Figure F)
8. Clip the factory trim panel over the
completed radio assembly to complete
the installation.
(Figure D)
(Figure E)
(Figure F)
REV. 6/5/2019 INST108-GM1G
3