Sensor Setting - Utilitech GYQ27-W Manual De Instrucciones

Installation is now complete. Turn on power at circuit breaker and flip wall switch to ON position.
Wall switch must remain in the ON position for the motion detector to work properly.
OPERATING INSTRUCTIONS

SENSOR SETTING

Mode
TEST
SECURITY
(DISTANCE)
DUSK TO DAWN
TIME DISTANCE Setting
Setting
TEST DISTANCE
1 Adjust the
"DISTANCE" to the L,
M, H. In default H
setting, the fixture will
detect the max range,
3
APROX 70 ft.
L: Up to 20-30 ft.
M: Up to 40-50 ft.
10 MIN
H: Up to 60-70 ft.
1
Adjust the "DISTANCE"
to "DUSK TO
3
DAWN".
10 MIN
TEST
Description
The sensor will detect movement and
the light will activate regardless of time
of day. After movement has stopped or
left the coverage area, the light will
remain on for about 5 seconds, then turn
off. Note: DUSK TO DAWN position is
forbidden.
At dusk, the motion sensor becomes
active. Any movement within the
coverage area will cause the light turn to
full brightness. After movement has
stopped, the light will remain on for the
preset time limit of 1, 3 or 10 minutes,
then turn off. The motion sensor will
remain active throughout the night. At
dawn, the motion sensor will deactivate
and remain deactivated throughout the
day. Movement will not cause the light to
turn on.
At dusk, the light will turn to low
brightness. Any movement within the
coverage area will cause the light to turn
to full brightness. After movement
has stopped, the light will remain on for
the preset time limit of 1, 3 or 10
minutes, then turn back to low
brightness. At dawn, the light will turn
off.
For the whole day, the light will remain
on at low brightness. Any movement
within the coverage area will cause the
light to turn to full brightness. After
movement has stopped, the light will
remain on for about 5 seconds, then
return to low brightness.
5