Utilitech GYQ27-W Manual De Instrucciones página 6

NOTE:
1. The sensor has a 14 second warm up period before it will detect motion. When turned on,
please wait 14 seconds.
If motion is continuously detected during the fixture's "ON" cycle,
2.
preset time limit of 1, 3 or 10 minutes, then turn off.
3. Manual Override: Force the fixture to override TEST and
SECURITY modes so the light will stay on. Turn the light on
manually from the wall switch. With the fixture already in the
ON position, flip the wall switch off and then back on twice in
3 seconds.
There are three ways to revert back to the previous mode:
●
Once again flip the wall switch off, wait for 10 seconds and
then back on.
●
If you leave the light on, the light will stay on for about 6
hours.
●
The brightness of environment is more than 100 LUX.
COVERAGE AREA
The motion detector has a coverage area of about 240° .
When the light is first installed, you must aim the detector
head to cover the desired area.
DISTANCE
To achieve max distance, the sensor angle will need to be adjusted according to the height at
which the fixture is installed.
6
the light will remain on for the