Testing And Adjustments; Important Considerations - Utilitech GYQ27-W Manual De Instrucciones

Assembly Height (ft.)
Recommend Sensor
Angle
Dead Zone (ft.)
(Dash area)
Max Distance (ft.)
NOTE:
1. The assembly height, sensor angle, and other data are the same for both wall and eave mount
installations.
2. At an ambient temperature of 77° F, the detection distance is at max. 65 ft. As the
increases or decreases, the detection distance will be reduced.

TESTING AND ADJUSTMENTS

1. Turn on the wall switch.
2. Switch to TEST position.
3. Walk through the coverage area noting where you are when the fixture turns on. Also, the
indicator light will flash several times when motion is detected.
4. If needed, adjust the motion sensor to change the detection zone.
5. If needed, adjust the lamp heads to change the light coverage area.
6. If you need to change the sensitivity, set the DISTANCE switch to desired position (L, M or H).
DISTANCE set too high may increase false trigger.
7. Finally, change the time setting to the amount of time the fixture should remain on after motion is
detected (1 min., 3 min., or 10 min.).

IMPORTANT CONSIDERATIONS

Avoid aiming the sensor at:
1. Objects that might produce heat and may cause false triggers, such as:
●
Pools of water
●
Automobile traffic
2. Objects that may reflect light at the sensor, triggering the shut-off feature. Do not aim the sensor
at other lights, or aim other lights at the sensor.
6 8
87° 84°
2.5 3
65 65
●
Air conditioners
●
Heating vents
10 13
82° 78°
4 5
65 65
●
Animals
●
Dryer vents
7
16 20
74° 70°
6 8
65 65
temperature