Battipav Class Manual De Instrucciones página 42

GB
18
Thanks to the great versatility of the CLASS/CLASSplus machine, it is possible to carry out different types of cutting.
Position the piece which needs cutting on the working table and make sure that it is properly leaned against the tile-stopper.
If necessary, a bearing square can be of help.
THE MILLIMETRE RULER PLACED ON THE WORKING TABLE HELPS ONLY WITH THE CARRYING OUT OF LINEAR
CUTTING.
19
In order to carry out any diagonal cutting lean the tile against the square the way it is shown in picture 12 and go on with the
cutting operation.
CUTTING A SURFACE AT 45°
Before positioning the motor head, make sure that:
• the machine is off; • the cutting tool is not moving;
45° CUT
20
Referring to the graded scale located on the machine upright, move the motor head to the jolly position and tighten the knobs.
With the locking lever, lower the cutting head until placing the blade some millimetres below the table level.
BEFORE ANY CUTTING MAKE SURE THAT THE TILE TO BE CUT IS PROPERLY LEANED AGAINST THE TILE-
STOPPER.
With the CLASS/CLASSplus machine it is also possible to set out:
a) the cutting length with the cutting adjustment knobs.
b) the cutting depth with the locking lever.
c) the straight cut measurement with the tile bearing square as well as the ruler placed on the working table.
21
In order to carry out special working it is possible to set out any cutting inclination ranging from 0° to 45° as marked on the machine side.
LASER MARKER
STANDARD FOR ART. 6xxxx1.
CLASS IIIA LASER INSTRUMENT
By means of the laser marker accessory, the cutting operations can be accelerated.
As a matter of fact, the special laser system is able to indicate the tool cutting line on the working table.
THE LASER MARKER STARTS WORKING ONCE THE MACHINE IS CONNECTED TO THE POWER SUPPLY. DIRECT EXPOSURE TO
SUNLIGHT MAY REDUCE THE LASER MARKER EFFECTIVENESS. IT IS THEREFORE ADVISABLE TO USE THE MACHINE INDOORS.
22
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that the line indicated by the laser marker matches the reference on the material to be cut;
• perform the cutting operation as indicated in the paragraph: "CUTTING ON THE TABLE".
DO NOT MODIFY THE MARKER POSITION BY TURNING THE BEAM TOWARDS THE OPERATOR'S EYES. DO NOT
GAZE AT THE BEAM WITH THE NAKED EYE OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line, its correct alignment can be adjusted.
In order to correctly position the marker, proceed as follows:
23
• loosen the three bulb locking screws so that it can be moved;
22
• position a reference properly on the tool cutting line;
23
• insert the 5 mm Allen wrench provided in the hexagonal slot located on the bulb;
23
• using the Allen wrench, turn the bulb until aligning the mark with the tool cutting line
DURING THE ADJUSTMENT OPERATIONS, MAKE SURE THAT THE LINE PRODUCED BY THE MARKER DOES NOT
REACH THE OPERATOR'S EYES.
ALWAYS KEEP A SAFETY DISTANCE BETWEEN THE OPERATOR'S EYES AND THE END OF THE LINE. THE MANUFACTURER
DECLINES ANY LIABILITY FOR THE USE OF THE LASER MARKER IN APPLICATIONS OTHER THAN THE INDICATED APPLICATION.
CUTTING PROGRESS SYSTEM
30
The "CUTTING PROGRESS SYSTEM" can be used to adjust – in a very precise manner and by means of the hand wheel
located on the machine front upright – the cutting head forward or backward movement.
GIVEN THE ACCESSORY HIGH SENSITIVITY, PROCEED WITH CAUTION SO AS NOT TO ACCIDENTALLY LOCK THE
CUTTING TOOL.
42
Battipav srl