Using The Tuner - Korg TMR-50 Manual De Usuario

contact mic into the TMR-50's INPUT jack.
If a device is not connected to the INPUT
jack, tuning will be performed by the
internal mic.
Connecting headphone
You can connect headphones with a 1/8"
mini-plug to the PHONES jack.
When plugged in, no sound will be heard
from the speaker. Use the volume control to
adjust the volume of the headphone output.

Using the tuner

Tuning while watching the meter (Meter mode)
1.
Connect your instrument cable or contact
mic to the TMR-50's INPUT jack.
If a device is not connected to the INPUT
jack, tuning will be performed by the
internal mic
16
2.
Press the TUNER ON button.
" " will appear at the top of
the display and the calibration (reference
pitch) will be displayed below that.
3.
To change the calibration, press the
CALIB/NOTE p or q button.
The calibration value increases and
decreases in units of 1 Hz. By pressing and
holding these buttons, you can increase
or decrease the value continuously. This
setting is stored even when the power is off.
4.
Play a single note on your instrument.
The closest note to the input sound will
appear in the center of the display. Tune
your instrument to the correct pitch, so that
the desired note name appears.
If you're using the internal mic, place your
instrument as close as possible to the mic
so that extraneous sound is not picked up
while tuning.