Storage; Tips; Troubleshooting - Vornado EV100 Guia Del Propietario

STORAGE

During the off-season or after extended periods of non-use, you
may choose to store your humidifier. To ensure long life of the
product, it is recommended to store your humidifier by following
these instructions:
Cleaning is recommended before storage.
1. Unplug power cord and bundle loosely.
2. Let humidifier dry completely before storing. Do not store with
water inside Water Tank or Base. Remove and discard Wick if it
is not suitable for reuse. Do not store humidifier with wet Wick. If
Wick is suitable for future use, remove and empty water from Base
and Water Tank. Replace Water Tank, power On and select HIGH
Fan Speed. Allow humidifer to run until Wick is completely dry.
3. Cover, or place back in retail carton if
available. This will prevent humidifier
from accumulating dust over time.
4. Store humidifier in cool and
dry location.
16 English

TIPS

Be aware of several things as your Vornado Evaporative Whole Room
®
Humidifier operates:
† If you operate your humidifier continuously (which is recommended
to maintain humidity all day), it may need to be refilled with water
every day. Check the Water Tank to be certain that there is an
adequate water supply for operation.
† Allow for optimum airflow by keeping the grill unobstructed.
Ensure curtains and other items are far enough away from the unit
to not be pulled into the side inlets or interfere with airflow.
† Any additives, such as aroma fragrances or water conditioners,
must not be used. These additives can cause cracks in the plastic
of the humidifier and may affect performance. Any use of such
additives voids the manufacturer's warranty.
DISPOSAL
Dispose of all packaging materials in an environmentally
responsible manner.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on. Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker/ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker/ground
fault circuit interrupter, or replace fuse. For assistance, contact licensed electrician.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit makes bubbling This is normal. Water is being dispensed into Base.
or gurgling sound.
Unit is not producing Water level in Tank is empty or too low. Refill with clean, cool tap water. See HOW TO USE for instructions.
desired amount
of humidity. Unit has reached its set point. When set humidity level is reached, the Fan will turn off until humidity level in
room drops below humidity set point.
Airflow is blocked. Remove obstruction.
Unit settings are too low. Set to High Fan Speed and Continuous Humidity for maximum humidity output.
Wicks are in need The additional sodium in chemically softened water may cause Wicks to harden. Try using untreated tap water or
of replacement distilled water.
too often.
Try adding Bacteriostat or Water Treatment, found at most hardware or home specialty stores to the water.
Or periodically remove the Wicks and clean by soaking them in solution of 1 teaspoon chlorine bleach and 1
gallon water. Let stand 20 minutes. Rinse thoroughly in cool water. Allow excess water to run off and dry before
replacing Wick in Base. DO NOT wring.
English
17