Publicidad
Idiomas disponibles
Idiomas disponibles
5. Attach the Connector to the Interior Assembly.
Important Note: To prevent damage, always handle the wire harness
with care.
a. Align the connector (smooth side up) with the connector port of the inte-
rior assembly.
b. For easier orientation, view the alignment of connection from the top of
the interior assembly.
c. Once aligned, push the connector in firmly to connect.
Top of
Interior
Assembly
6. Install Interior Assembly.
a. Making sure wires are clear of pinching and wire harness is routed as
shown, place the interior assembly on door, aligning torque blade inside the
turnpiece shaft.
Turnpiece
Shaft
b. Once flush on door,
insert and tighten small screws
to secure assembly onto the
mounting plate. Note: To aid insertion of screws,
approach the screw holes with the screw loaded onto the screwdriver.
4
Interior
Assembly
Connector
Connector Port
Small
Screws
Wire Harness
Route wires down - avoiding any
excess bulge at curve, which could
interfere with battery pack installation.
Wire Harness
Torque Blade
Connector
Publicidad
