Transport And Storage; Safety - Amprobe AC50A Manual De Uso

1.800.561.8187
Contents:
1 Current Clamp AC50A
2 Test leads with probes (red/black)
2 Batteries 1,5V IEC LR6
1 Carrying case
1 User manual

Transport and Storage

�

• Please keep the original packaging for later transport, e.g. for calibration.
Any transport damage due to faulty packaging will be excluded from
warranty claims.
• In order to avoid instrument damage, it is advised to remove batteries
when not using the instrument over a certain time period. However,
should the instrument be contaminated by leaking battery cells, you are
kindly requested to return it to the factory for cleaning and inspection.
• Instruments must be stored in dry and closed areas. In the case of an
instrument being transported in extreme temperatures, a recovery time
of minimum 2 hours is required prior to instrument operation.
�� Safety
The Meter complies with:
- IEC/EN 61010-1:2010 Third edition to Measurement Category III
300 V and Measurement Category II 600 V, Pollution Degree 2
- IEC/EN 61010-2-030
- IEC/EN 61010-031 for test leads
- IEC/EN 61010-2-032
- EMC meets all applicable requirements in IEC/EN 61326-1
• The AC50A has been manufactured and tested to comply with the
safety regulations for electronic measuring equipment contained in
IEC61010 and EN 61010, and left the factory in a safe condition. To
maintain this condition, the user must observe the safety instructions
contained in this users manual.
• To avoid electric shock, safety measures must be observed when working
with voltages higher than 60V DC or 30 V RMS (42.4 V peak).
• Before each measurement make sure that the test leads and the
instrument are undamaged.
• Only handle test leads and probes on the grips provided. Avoid
touching probes under any circumstances.
• Measurements in dangerous proximity of electrical installations are
only to be executed when instructed by a responsible electrical
specialist, and never alone.
• The relevant safety regulations for electrical plant and equipment
must be observed during all operations.
• The instrument must only be used in the specified ranges.
• Before opening the instrument, it must be disconnected from all circuits.
• Protect the instrument from prolonged exposure to direct sunlight.
5
www. .com
information@itm.com