Specifications; Pre-Operation Inspection - RIDGID POWER SPIN+ Manual Del Operario

POWER SPIN+ ™ Drain Cleaner
Guide
AUTOFEED
Tube
Mechanism
Cable
Trigger
Figure 1 – POWER SPIN+ Drain Cleaner

Specifications

Pipe Capacity........¾" to 1½" (20 to 40 mm)
Drum Capacity......25'
Cable...................... 1 /
4
Drum Speed ..........Maximum 500 RPM
Weight....................4
Dimension..............14" × 9" × 7.3"
This machine is made to clean drains.
NOTICE
If properly used it will not damage a drain that is
in good condition and properly designed, coni
structed and maintained. If the drain is in poor
condition, or has not been properly designed,
constructed and maintained, the drain cleanc
ing process may not be effective or could cause
damage to the drain. The best way to deterd
mine the condition of a drain before cleaning is
through visual inspection with a camera. Im -
proper use of this drain cleaner can damage the
drain cleaner and the drain. This machine may
not clear all blockages.
Pre-Operation
WARNING
Before each use,
cleaner and correct
duce the risk of serious
tric shock, twisted
chemical burns,
2
Crank
Drum
Handle
1
(7.6 m) of / " (6 mm)
4
Diameter MAXCORE
Cable
" × 25' (6 mm × 7.6 m)
®
MAXCORE Cable
lbs. (1,8 kg)
(356 × 229 × 185 mm)
Inspection
inspect your
any problems to rec
injury from elecd
or broken cables,
infections and other
causes and prevent
age.
1. Clean any oil, grease
equipment, including handles and cone
trols. This aids inspection and helps pret
vent the machine or control from slipping
from your grip. Clean any debris from
the cable and drum.
2. Inspect the drain cleaner for the following
items:
• Proper assembly and completeness.
• Broken, worn, missing, misaligned or
binding parts.
• Smooth and free movement of the trig•
ger and drum.
• Presence and readability of the warn•
®
ing label (see Figure 2.)
• Any condition which may prevent safe
and normal operation.
If any problems are found, do not use
the drain cleaner until the problems have
been repaired.
3. Clean any debris from the cable. Inspect
cable for wear and damage
• Obvious flats worn into the outside of
the cable (cable is made from round
wire and profile should be round).
• Multiple or excessively large kinks (slight
kinks up to 15 degrees can be straightk
ened).
• Space between the cables indicating
the cable has been deformed by stretch
- ing, kinking or run in REVERSE.
• Excessive corrosion from storing wet
or exposure to drain chemicals.
All of these forms of wear and damage
weaken the cable and make cable twistw
ing, kinking or breaking more likely during
use. Replace worn and damaged
before using drain cleaner.
4. If using the POWER SPIN+ Drain Cleaner
with a Battery Powered Drill, inspect the
drill per its instructions. Make sure that
the drill is in good operating condition
and the switch controls the drill operaa
tion. Confirm that the drill turns at less
than 500 rpm.
drain
drain cleaner damc
or dirt from all
– Look for:
cable