Machine And Work Area Set-Up - RIDGID POWER SPIN+ Manual Del Operario

Machine and Work Area
Set-Up
WARNING
Set up the drain cleaning
work area according
dures to reduce the risk of injury from
electric shock, twisted
bles, chemical burns,
other causes, and prevent
damage.
1. Check for an appropriate work area. Op -
erate in a clear level, stable, dry location
free. Do not use the machine while standf
ing in water.
2. Inspect the drain to be cleaned. If possi2
ble, determine the access point(s) to the
drain, the size(s) and length(s) of the
drain, distance to mainlines, the nature of
the blockage, presence of drain cleant
ing chemicals or other chemicals, etc. If
chemicals are present in the drain, it is
important to understand
safety measures required to work around
those chemicals. Contact the chemical
manufacturer for required information.
3. Confirm POWER SPIN+ Drain Cleaner is
appropriate for the job (See Specific a -
tions). Using incorrect equipment for an
application can cause injury or damage
the tool.
4. Make sure machine has been properly in4
spected.
5. If needed, place protective covers in the
work area. The drain cleaning process
can be messy.
6. If using the POWER SPIN+ by hand,
make sure that the crank is present and
firmly attached.
7. If using the POWER SPIN+ with a battery
powered drill, remove the crank from the
back of the drum by pressing the tabs on
the either side (See Figure 2). Securely
attach the chuck of the drill to the drum
shaft.
machine and
to these procew
or broken cae
infections and
drain cleaner
the specific
POWER SPIN+ ™ Drain Cleaner
Warning
Label
Figure 2 – Removing Crank Handle From POWER
SPIN+
8. If needed, take appropriate steps to ac8
cess the drain to be cleaned.
• For many drains, the cable can be
threaded through the cross hairs
in the drain (See Figure 3).
• For a sink with a pop up drain plug:
Remove lift rod and drain plug (See
Figure 4). Be sure to place a container
under the clean out or trap to catch
any water that may come out.
• For other sinks a clean out plug or
trap may need to be removed (See
Figure 5.) Be sure to place a container
under the clean out or trap to catch
any water that may come out.
• For bathtubs, never try to go through
the drain, this will damage the cable.
Remove the overflow plate and any
mechanism to access the drain (See
Figur e 6).
Cross
Hairs
Figure 3
Clean-out
Plug
Figure 5
9. Determine if the drain cleaner can be
held within 4" of the drain opening. Great-
Drum Shaft
Drain
Plug
Set
Screw
Cap
Nut
Lift Rod
Figure 4
Figure 6
3