DeWalt D28730 Manual De Instrucciones página 9

Ocultar thumbs Ver también para D28730:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. E
15
5
Fig. F
26
5
Removal and Installation of Wheels
(Fig. G, H)

WARNING: Turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. Do not make
any adjustment while the wheel is in motion. Do not
make any adjustment while chop saw is plugged into
power supply.

WARNING: Use only bonded reinforced cut-off wheels
for your power tool. A bonded reinforced wheel is
defined as a grinding wheel consisting of abrasive
particles bonded together with various substances
specifically for cutting steel materials.

WARNING: Always use gloves when
handling wheels.

WARNING: Handle and store all abrasive wheels
carefully to prevent damage from thermal shock, heat,
mechanical damage, etc. Store in a dry protected area
free from high humidity, freezing temperatures or
extreme temperature changes.

WARNING: Do not impact the wheel, and do not use
a wheel that has been dropped or impacted. Do not
use a chipped, deformed or damaged wheel.
1. Push in spindle lock 
 12
and rotate wheel 
until wheel lock lever engages slot in inside flange 
to lock wheel. Loosen the bolt 
the center of the abrasive wheel with the 5/16" (8 mm)
hex key 
 7
. Bolt has right-hand thread.
6
15
 10
by hand
 27
counterclockwise in
 19
Fig. G
12
2. Remove the bolt 
 19
, washer 
and old wheel 
 10
.
Fig. H
27
3. Make sure flange surfaces are clean and flat. Install the
new abrasive wheel by reversing the above steps.
4. For safe operation, securely tighten bolt
secure the abrasive wheel
outer flanges 
 21 
. Do not overtighten bolt

WARNING: Check the work surface that the chop saw
rests on when replacing with a new abrasive wheel. It
is possible that the wheel may contact ANY ITEMS OR
STRUCTURE THAT EXTENDS ABOVE work surface
(under the base) when the arm is fully lowered.
Operation Tips for More Accurate Cuts
Allow the wheel to do the cutting. Excessive force will
cause the wheel to glaze reducing cutting efficiency
and/or to deflect causing inaccurate cuts.
Properly adjust fence angle.
Make sure material is laying flat across base.
Properly clamp material to avoid movement
and vibration.
Motor Brush Inspection and Replacement
(Fig. I, J)
BE SURE TOOL IS UNPLUGGED BEFORE INSPECTING
BRUSHES. Brushes should be regularly inspected for wear.
To inspect brushes, unscrew the two end cap screws 
and remove the end cap 
 23 
first unplug the shunt wire terminal connection 
English
 20
, outside flange 
 21
10
21
20
19
to firmly
 19 
in between inner
and
 10 
 18 
 19 
.
 22 
. To remove each brush 
 24 
,
. Then
 25 
7

Publicidad

Tabla de contenido
loading

Tabla de contenido