Siemens 1FK6 Instrucciones De Servicio página 308

Faults and Alarms
Number / Alarm Cause
A150 The selected NC program contains a slave
axis which is already being used by another
Slave axis already master axis (M7 only, not significant for the
allocated to other F01 technology option).
master axis
Example:
NC program 1, started in axis X, contains NC
blocks for axes X and Y. NC program 2 is
started in axis Z and contains NC blocks for
axes Z and Y. This program is denied with
warning 150, because axis Y is already being
used by program 1.
Effect:
NC program execution is inhibited or aborted.
A151 The slave axis required by the master axis is
not in "slave" mode (M7 only, not significant
Slave axis operating for the F01 technology option).
mode not allowed
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
A152 The "slave" mode was deselected in the slave
axis during the traversing movement (M7 only,
Slave axis operating not significant for the F01 technology option).
mode changed
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
A153 A warning is active in the slave axis required
by the master axis (M7 only, not significant for
Error in slave axis the F01 technology option).
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
A154 The "follow-up mode" [FUM] control signal is
active in the slave axis required by the master
Follow-up mode in axis. A slave axis which is switched to follow-
slave axis active up mode cannot be operated by the master
axis (M7 only, not significant for the F01
technology option).
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
A155 The "reset" [RST] control signal is active in the
slave axis required by the master axis. A slave
Reset in slave axis axis with an active reset cannot be used by the
active master axis (M7 only, not significant for the
F01 technology option.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
12-24
Counter-measure
The same slave axis cannot be used
simultaneously by several NC programs.
The slave axis must be switched to "slave"
mode.
The slave axis must remain switched to
"slave" mode.
The NC program will only run if all of the axes
it needs are error-free. To clear this warning,
you must first clear all the warnings in the
slave axis.
Deactivate follow-up mode in the slave axis.
Cancel the "reset" [RST] control signal in the
slave axis.
6SE7087-8JP50
Operating Instructions SIMOVERT MASTERDRIVES
08.2006
Siemens AG