Step 3: Connect Drain Hose To Drain Receptacle - Alliance Laundry Systems H264I Instalación Y Operación

Step 3:
Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on the
rear of the washer by unhooking the hose from the
retainer clamp.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-3/8 inch (35 cm) outside
diameter drain hose.
8
RETAINER
CLAMP
H139IE3A
Standpipe Installation:
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories bag
and place around standpipe and drain hose and tighten
strap to hold hose to standpipe. This will prevent the drain
hose from dislodging from drain receptacle during use.
24" to 36"
(61 to 91.44 cm)
Recommended
Height
STANDPIPE
2" (5.08 cm) or
1-1/2" (4 cm)
H138IE3A
800138