Step 4: Remove The Shock Sleeves And Shipping Brace; Step 5: Position And Level The Washer - Alliance Laundry Systems H264I Instalación Y Operación

Step 4:
Remove the Shock Sleeves and
Shipping Brace
Remove front access panel by removing the two screws.
Remove bolts and washers from shipping brace with
9/16" wrench and remove brace. Remove shock sleeves
by pulling on the yellow rope. Remove label from front
side of front access panel and place on backside of front
access panel.
NOTE: The shipping brace, bolts, washers and shock
sleeves should be saved and MUST be reinstalled
whenever the washer is moved more than four feet.
Do not lift or transport washer from front or without
shipping materials installed.
Store the shipping materials in the bag provided in the
Accessories Bag. Save materials for use whenever the
washer is moved.
Reinstall front access panel.
HOOKED
END OF
SHIPPING
BRACE
BOLTS
NOTE: The shipping materials MUST be reinstalled
whenever the washer is moved. Refer to Moving
Washer to a New Location section for instructions.
800138
SHOCK SLEEVES
MOTOR
MOUNT
H027IE1B
WASHERS
Step 5:
Position and Level the Washer
Place washer in position on a clean, firm and reasonably
level floor. Installing the washer on any type of carpeting
is not recommended.
Loosen 9/16" locknuts and adjust the leveling legs until
the washer does not rock.
NOTE: Level must rest on raised portion of top panel.
See illustration.
Tighten the locknuts securely against the washer base
using the 9/16" wrench. If the locknuts are
not tight, washer will move out of position during
operation.
CAUTION
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
Remove rubber feet from accessories bag and place on all
four leveling legs.
WASHER
BASE
LEVELING
LEG
RUBBER
CUP
W248
W185
LEVEL
H223IE1A
LOCKNUT
9