Tabla de contenido
Publicidad
AFTER EACH USE
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
•
Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
•
To clean unit, wipe with a damp cloth and dry immediately.
•
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
WASHABLE BLADE CLEANING
•
To remove the blades ensure the unit is off. Press the blade release button on the back
of the clipper where it meets the blade and push away from the clipper.
•
To reattach once the blades are cleaned and dry, align the bottom of the blade with the
bottom blade housing tab and slide the cartridge back into place until you hear a click.
•
Do not run the entire unit under the tap, only the blade set is meant to be submerged in
water.
•
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
EVERY SIX MONTHS
•
Remove the 2 screws retaining the fixed blade with a screwdriver.
•
Remove the blade set.
•
Brush out hairs from between the blades with a soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
•
If the moving blade has been removed this can be re-fitted by slotting the moving
blade holder over the pin in the centre of the interior product head.
•
The groove on the moving blade just below the teeth should rest on the plastic pressure
arm which rides inside the groove. The fixed blade should be assembled with the
bevelled edge of the 2 screw holes facing outward and fixed with screws.
•
Note that if the blades are not correctly aligned then cutting efficiency will be impaired.
CLEANING CAUTIONS
•
Cleaning should only be done with a soft brush, such as the brush supplied with the
product.
•
Do not rinse under water.
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Ensure the appliance is switched off and unplug from the main outlet before cleaning.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the trimmer until it stops.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
7
Publicidad
Tabla de contenido
