Connecting Up - TAD D1000MK2 Manual De Instrucciones

connecting up

CAUTION
' Do not turn on the power switch to the TAD-D1000MK2 or the other components until all connections have been
completed.
' When connecting components or changing connections, always set the power switch to OFF and disconnect the power
cord from its AC outlet. When making connections, connect the power cord last.
• Although the power cord to the TAD-D1000mK2 is removable, do not attempt to use a power cord
other than the supplied cord.
1. Connect other components.
2. Connect the supplied power cord to the TAD-D1000mK2's AC IN connector.
3. Connect the power cord to a standard electrical outlet.
Computer with USB port
1. Turn on power to both the unit
and computer.
2. Switch the unit's input to U1.
3. Using a USB cable, connect
the computer and unit; when
this is done the proper driver
will be automatically installed
(page 17).
BALANCED
output connector
(XLR-3-31 equivalent)
1
2
3
1: Ground
2: Hot
3: Cold
Pre-Amplifier with balanced input connectors
note
Digital output during CD play
' During CD play, 44.1 kHz/16-bit digital signals are output; digital output is disabled, however, when playing SACD media.
Component with digital output connector
USB XLR COAXIAL
D1 D2 D3
DIGITAL INPUT
R L R L
BALANCED UNBALANCED
AC IN
OPT 12 V XLR COAXIAL
D4 TRIGGER
IN
Component with digital input connector
R L
Pre-Amplifier with unbalanced input connectors
Component
with 12 V trigger output connector
Power cord
(supplied)
To AC
Power outlet
15