Measuring; Weight Only; Switching Off The Diagnostic Scales; Configuring Users - Silvercrest SBF 75 Instrucciones De Utilización Y De Seguridad

Operation
Important for measurements: the body fat per-
centage can only be determined if you are ba-
refoot. If necessary, slightly moisten the soles of
your feet.
Note: Completely dry or very calloused feet
may provide poor results, as the conductivity
will be too low.
Note: Do not allow the feet, legs, calves or
thighs to touch. This will interfere with measure-
ment.
Note: Wearing socks will provide false results.
Stand upright and still during measurement,
with the weight distributed equally between
both legs.
Please note, only the long-term trend is impor-
tant. Sudden weight changes within a few days
are typically caused by loss of fluids; however,
hydration is important for your well being.
Note: The units of measure for the scales can be
changed in the app, under device settings (kg / lb / st).

Measuring

Step on the diagnostic scales barefoot and be
sure to stand still on the electrodes
weight distributed equally between both legs.
The diagnostic scales will start to measure immedi-
ately. They will first show the weight
measuring other parameters the display will read
„oooo".
The results will appear shortly after.
If a user has been assigned (the user initials
appear, e.g. LEE), BMI, BF, water, muscle, bone,
BMR and AMR will be displayed.
The following information will be displayed:
- Weight in kg with BMI (Fig. C)
6
- Body fat in % (BF) (Fig. D)
13
- Body water in % (Fig. E)
13
- Muscle mass in % (Fig. F)
13
- Bone mass in kg (Fig. G)
13
- Basal metabolic rate
- Active metabolic rate
If a user is not recognised, only the
weight will be displayed along with „- - -".
56 GB/MT
with the
5
. Whilst
6
will
14
in kcal (BMR) (Fig. H)
8
in kcal (AMR) (Fig. I)
9

Weight Only

Stand on the diagnostic scales wearing shoes.
Stand still on the diagnostic scales with the
weight distributed evenly between both legs.
The diagnostic scales will start to measure immedi-
ately. The weight will be displayed, and the LC-dis-
play will cycle through „- - - -".
1
If a user has been assigned (the user initials
appear, e.g. LEE), the BMI, BMR and AMR will be
displayed.
If a user is not recognised, only the weight will be
displayed along with „- - -".
Switching Off the
Diagnostic Scales
The diagnostic scales feature an auto shut-off and
will automatically switch off after displaying the
results.

Configuring Users

The weighing scales are able to save measurements
from up to 8 different users. Upon starting a new
measurement, the diagnostic scales will assign the
measurement automatically to the created user:
- in the case of a measurement of weight only (in-
cluding shoes): to the user whose last saved value
lies within the range of +/- 2 kg of the new
measurement
- in the case of measurement of a diagnosis
(barefoot): to the user whose last saved value lies
within the range of +/- 2 kg or +/- 2% of BF from
the new measurement
If more than one user falls into the same range, the
measurement will be saved as an unknown user.

Unknown Value

If values cannot be matched with a user, the diag-
nostic scales will save these values as unknown val-
ues. The LC-display
1
14
will read „- - -" under initials
will