Installing And Removing The Battery Pack; Optional Accessory - DeWalt DWH161 Manual De Instrucciones

English
iMPORTAnT: When attaching or replacing the belt
hook 15 , use only the screw
securely tighten the screw.
If the hook is not desired at all, it can be removed from
the tool.
Fig. E
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.

WARNING: Do not use the dust extraction system
without the filter in place.

Installing and Removing the Battery Pack

(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 1
the battery pack with the rails and slide it in until the battery
pack is firmly seated in the dust extractor and ensure that it
does not disengage.
To remove the battery pack from the dust extractor, press
the release button 2 and firmly pull the battery pack out of
the dust extractor. Insert it into the charger as described in
the charger section of this manual.
8
16 that is provided. Be sure to
16
15
17
into the dust extractor, align
Fig. F
2
D WALT Tool Tag Ready (Fig. E)
e

Optional Accessory

Your tool comes with mounting holes
installing a D WALT Tool Tag. You will need a T15 bit tip to
e
install the tag. Only use the screws provided. The D
Tool Tag is designed for tracking and locating professional
power tools, equipment, and machines using the D
Tool Connect™ app. For proper installation and use of the
D WALT Tool Tag refer to the D
e
Using the Dust Extractor (Fig. A, G)
1. Attach the appropriate accessory to the dust extractor
hose 6 .
2. Insert the battery pack
1
3. To turn dust extractor on, press the three position
switch 7 to the On (I) position.
4. To use in Wireless Tool Control™ mode press the three
position swtich to the Wireless Tool Control™ ( ) position.
The trigger of the connected tool or the button on the
remote will control the dust extractor.
nOTE: Refer to Pairing the Dust Extractor with a Tool
using Wireless Tool Control™ Mode to use the dust
extractor with a Wireless Tool Control™ equipped tool
or remote.
5. When finished, turn the dust extractor off by pressing
the three position switch to the Off (O) position or
releasing the trigger of the Wireless Tool Control™
equipped tool or the button on the remote.
Fig. G
8
7
1
17 and fasteners for
WALT
e
WALT
e
WALT Tool Tag manual.
e
.
9