MoJack EZ Max Instrucciones Para El Montaje Y La Operación página 5

Assembly Instructions
STEP 4
Assemble Base with Wheels to the
4
Base Floor Tube by inserting the two
3
Flange Bolts , Washers and
10 14
Nylon Lock Nuts and tighten with
13
15mm wrenches.
Nylon Lock Nuts 13
Base Floor Tube 3
STEP 5
Insert the Tower Assembly 1 to the
Base with Wheels and affix with
4
Clevis Pin and Hair Pin as shown.
17 18
STEP 6
Push in side of handle and
rotate from storage position
to the operating position.
Allow to seat into the locked
position.
MoJack EZ Max Lift
4 Base with Wheels
Washer 14
10 Flange Bolts
1 Tower
4 Base with Wheels
18 Hair Pin
17 Clevis Pin
Locked Position
8
Assembly Instructions
STEP 7
Insert the Lift Arm into the Carrier
2
and insert the Clevis Pin through the
17
hole in Carrier and lock by fastening the
Hair Pin to the Clevis Pin.
18
STEP 8
Slide the Wheel Pad Lift Arms 6
onto both sides of the Lift Arm and
2
secure with Push Pins .
16
NOTE: The Wheel Pads can be moved
in or out to fit different mower widths.
Use the configuration that works best
with your model of lawn mower.
NOTE: The Safety Straps must
be used during operation
(see Step 9 of the Operating
6 Wheel Pad Lift Arm
Instructions).
WARNING: Wheel pads must be equal distance from the Lift Arm to maintain proper balance.
For additional information, see see Step 6 of the Operating Instructions.
THIS COMPLETES ASSEMBLY.
MoJack EZ Max Lift
Hair Pin 18
17
Lift Arm 2
Lift Arm 2
16 Push Pin
Push Pin 16
Wheel Pad Lift Arm 6
9
Carrier
Clevis Pin