MoJack EZ Max Instrucciones Para El Montaje Y La Operación página 9

Operating Instructions
STEP 14
Removing the Mower from the MoJack EZ Max
• Remove the Safety Straps from front mower tires.
• Drive or roll the mower off of the Wheel Pads.
STEP 15
Raising the MoJack EZ Max with a power drill
(optional – power drill not included)
The MoJack EZ Max can be raised or lowered by
using a variable speed corded drill (7 amp minimum)
or variable speed cordless drill (18V minimum).
The drill will require a 3/8" square driver (not included).
• Remove Crank Handle by taking off the Nylon Lock
Nut and Spring using 15mm wrench.
After Crank Handle removal, re-attach Spring and
Nylon Lock Nut to Crank Handle to prevent loss.
• Firmly insert the 3/8" square driver in the Square
Receiver. Rotate the drill forward (clockwise) to
raise the Lift Arm and rotate the drill in reverse
(counterclockwise) to lower the Lift Arm.
• Carrier Locking Handle must be manually pulled out when lowering
until it clears the bottom Tower Hole.
Operator must have a firm grip on the drill before raising or
lowering the Lift Arm.
NOTE: Crank Handle must be removed in order to use the drill attachment.
Follow all other operating instructions while using the drill attachment.
Replace the Crank Handle as necessary for future use.
NOTE: When re-assembling handle, take care not to over-tighten
the Nylon Lock Nut against the spring. There should be enough free
space for the handle to be pushed in to move from storage position to
operating position.
MoJack EZ Max Lift
Square
Receiver
Square Driver not included
Before using a drill,
remove the Crank
Handle
Crank
Handle
Spring
16
Preparing for Storage (Steps 16 - 20)
STEP 16
Removing the Wheel Pads
• Remove Push Pins and
pull the Wheel Pad
Lift Arms out of the
Lift Arm.
• Store the Push Pins
in the Lift Arm to
prevent loss.
Make sure drill
is fully charged
and set at highest
torque.
3/8"
STEP 17
Square
Driver
Removing the Lift Arm
• While holding the Lift Arm, remove the
Hair Pin and Clevis Pin from Lift Arm.
• Slide the Lift Arm out of the Carrier.
• Store the Hair Pin and Clevis Pin in the
Lift Arm to prevent loss.
Nylock
Locking
Nut
MoJack EZ Max Lift
Operating Instructions
Lift Arm
Push Pin
Wheel Pad Lift Arm
Hair Pin
Lift Arm
17
Push Pin
Wheel Pad Lift Arm
Carrier
Clevis Pin