Device Specific Safety Notes - Silvercrest 313492 Instrucciones De Utilización Y De Seguridad

falls into water, first unplug it
from the mains, then remove it
from the water! Do not operate
the device after this until it has
been inspected by an approved
service point. This also applies if
the mains cable
becomes damaged or the device
has been dropped!
DANGER OF ELECTRIC
SHOCK! Make sure that the
mains cable
are never placed on hot surfaces
or near sources of heat. Lay the
mains cable
3
it does not come into contact
with hot or sharp-edged objects!
DANGER OF ELECTRIC
SHOCK! Never kink the mains
cable and do not wrap it
3
around the device, as these could
cause a cable rupture!
DANGER OF ELECTRIC
SHOCK! Do not use the device
whilst standing on a wet floor or
if your hands are or the device is
wet!
DANGER OF ELECTRIC
SHOCK! Never open the device
and never attempt to get inside it
using metal objects!
Repairs may only be performed
by approved specialist workshops.
36 GB/MT
or the device
3
and the device
3
in such a way that
Improperly repaired devices may
be dangerous for the user.
Only connect the device to a
properly installed safety socket
with a suitable mains voltage
(see chapter „Technical data").
To prevent accidents, do not
leave the device unattended
while it is operating.
Device specific
safety notes
Do not use the device on unstable
or sloping surfaces.
Do not remove the mains cable
from the plug before process-
3
ing is complete. If you have to
pause processing, remove the
mains cable from the plug
3
before carrying out further pro-
cesses.
It is recommended to rest the
machine for at least 20 minutes
after four cycles in a row, so that
the motor can cool down.
If you want to use the device
without interruption, clean the
shaping disk
16
each use with the cleaning tool
included. To make cleaning
14
easier, do not immediately
last used after