Publicidad
STEP 2C Attach Wall Plate to Wall
Min.
1/2 in.
(13 mm)
CAUTION
: Avoid potential personal
injuries and property damage!
●
Studs must be at least 2x 4 in. / 25 ga.
●
Stud type and structural strength must
conform to the North American Specification
for the Design of Cold-Formed Steel
Structural Members
[362 S 125 18, C-Shape, S - Stud Section].
●
If back side of wall is unfinished, drywall must be
installed to a minimum of one stud left and right
of the stud(s) being used to install the mount.
●
Drywall must be a minimum of 1/2 in. (13 mm)
thick on each side of the studs, and a minimum
clearance of 1⅞ in. (48 mm)
behind the wall is required.
●
Drywall must be secured to studs with
screws 12 in. (304.8 mm) on center.
●
This product must be centered on the studs.
16
Steel Stud Installation
Steel Stud Anchor Kit SSMK1 is not included
Customer Service at 1-888-333-9952 to have the additional hardware
shipped directly to you.
1.
Locate stud.
2.
Level the wall plate template
1
(see page 6) Contact
and mark the hole locations.
14
2
14
A Y U
P
Publicidad
