Comutech 100603 / HB-1208CS Manual De Usuario página 14

grounded to chassis (as in most vehicles), see (e). If the positive post is grounded to the chassis.
e. For negative-grounded vehicle, connect POSITIVE (RED) clip from battery charger to
POSITIVE {POS, P, +) ungrounded post of battery. Connect NEGATIVE (BLACK) clip to
vehicle chassis or engine block away from battery. Do not connect clip to the carburetor, fuel
lines, or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine
block.
f. For positive-grounded vehicle, only connect NEGATIVE (BLACK) clip from battery charger
to NEGATIVE (NEG, N, -) ungrounded post of battery. Connect POSITIVE (RED) clip to
vehicle chassis or engine block away from battery. Do not connect clip to the carburetor, fuel
lines, or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine
block.
h. See operating instructions for length of charge information.
Follow these steps when battery is outside vehicle. A spark near battery may cause battery
explosion. To reduce risk of a spark near battery:
a. Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has larger
diameter than NEGATIVE (NEG, N, -) post.
b. Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.
c. Position yourself and free end of cable as far away from battery as possible-then connect
NEGATIVE (BLACK) charger clip to free end of the cable.
d. Do not face battery when making final connection.
e. When disconnecting charger, always do so in the reverse sequence of connecting procedure
and break first connection while as far away from the battery as practical. .
f. A marine (boat) battery must be removed and charged on shore. To charge it on board requires
equipment specially designed for marine use.
1. Maintain labels and nameplates on the Battery Charger. These carry important information. If
unreadable or missing, contact your dealer.
2. Always wear safety impact eye goggles and heavy work gloves when using
the Battery Charger. Using personal safety devices reduce the risk for injury.
Safety impact eye goggles and heavy work gloves are available from your dealer
3. Maintain a safe working environment. Keep the work area well lit. Make sure there is
adequate surrounding workspace. Always keep the work area free of obstructions, grease, oil,
trash, and other debris. Do not use a power tool in areas near flammable chemicals, dusts, and
vapors. Do not use this product in a damp or wet location.
4. Avoid unintentional starting. Make sure you are prepared to begin work before turning on the
Battery Charger.
5Always unplug the Battery Charger from its electrical outlet before
SAVE THESE INSTRUCTIONS
Specific Safety Rules for the Battery Charger
14