Steelcase 488 Brody Manual Del Usuario página 12

®
Side Surface
Replacment
1.
Using a 4mm allen wrench,
loosen the four (4) M6 bolts that
attach the side surface to the
frame and personal worksurface.
2.
Pull the side surface towards
the front of the unit approximately
three quarters of an inch to
disengage the z-bracket from the
wooden wall.
Side Surface
Replacement
3.
Using a 4mm allen wrench,
attach the rear z-bracket with the
opening facing rearward as shown.
4.
Using a 5mm allen wrench,
attach the M6 socket head cap
screw and star washer into the
outer most threaded insert.
NOTE: IF A mini Dash light needs
to be installed. It is easiest to
install the bracket for it at this time
before attaching the side surface
to the Brody unit.
5.
Reverse steps 1 thru 3 to
compete assembly of new side
surface.
SIDE SURFACE
1
M6 BOLT
WOODEN WALL
Z BRACKET SHOWN
ENGAGED WITH WOODEN WALL
2a
NOTE: Seat removed from
illustration for clarity.
Z BRACKET SHOWN
DISENGAGED FROM
WOODEN WALL
M6 SOCKET
HEAD CAP SCREW
3
4
4MM HEX
Z BRACKET
SIDE SURFACE
Page 12 of
113157