Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
®
Non – Personal
Worksurface Bracket
Replacement
(continued)
4.
Using a 6mm Allen wrench,
remove the two (2) M8 fasteners
holding the side surface to the upper
casting on the personal worksurface.
5.
Using a T40 torx bit, remove the
two (2) M6 bolts (5a) and the one (1)
M8 bolt (5b) holding the personal
workurface to the steel frame.
6.
Carefully slide the personal
workurface out from underneath the
side surface.
NOTE: Do not load the side surface
with the support bracket removed.
7.
Reverse steps 4 thru 6 to install
new non-PSW bracket.
NOTE: Side surface
removed from illustration
for clarity.
M8 BOLT
UPPER
4
CASTING
NON-PWS BRACKET
5a
M6 BOLT
NON-PERSONAL
WORKSURFACE
BRACKET
SIDE SURFACE
5b
M8 BOLT
Page 14 of
113157
Publicidad
Capítulos
Tabla de contenido
