Publicidad
Idiomas disponibles
Idiomas disponibles
Disassembly of the band saw head
Remove hexagonal nut m, spring washer n and snap ring o. Pull out the adjusting screw p.
Loosen socket head screw q. Take out fixing plate r, adjusting plate s and tension springs t.
Pull needle sleeves u from the shaft v and out of the band saw frame J. Press out the
grooved ball bearing w. Remove tension sleeve x. Separate tension lever y from the eccentric
shaft z . (see fig. 14).
Re-assembly of the band saw head
The re-assembly of the band saw head is done in reverse order
Check the smooth running of the pulleys by turning them by hand. Then screw-on the
pneumatic motor.
Disassembly of the clamp
Loosen tenion lever Aa and hexagonal nut Bb. Remove swivel arm Cc. Remove socket head
screws Dd and the bench vice Ee. Remove the hexagonal nut Ff. Pull out the stop Gg (see
fig.15).
80
Publicidad
