Function Messages; Error Messages - Neumann MINIMISSION Manual Del Usuario

Your PIN code

Function messages

Error messages

Cutting grass according to the program setting.
When it senses rain, Minimission
time you have programmed it to do so. When dry, Minimission
the delay and countdown and then return to mow. If you want Minimission
before this, simply turn it off then on again, but only when the rain sensor is dry or you
can set the delay time to 0 min.
Needs to recharge—during the journey to the base, the cutting blade is stopped in order
to save energy.
Charge is in progress—charge percentage are displayed.
Stand-by, will start according to program set.
According to the setting of "Customize work area" , Minimission
area to mow.
Minimission has completed its charging.
®
1. If Minimission is actually outside its territory: turn power off, take the Minimission
®
its territory. Turn power on.
2. If the Minimission is inside its territory, check the LED on the charging base is green.
®
If not, check the charging base is connected properly to the charger and the charger is
connected to a suitable power supply. If so, it means that the boundary wire ends are
clamped incorrectly, and you need to reverse them.
3. If the LED light flashes green, check the boundary wire is well connected to the clamps to
the charging base. If the problem persists, check that the boundary wire hasn't been cut.
Refer to the "Programming" section to re-set your PIN.
1. Turn power off.
2. Turn Minimission upside down and check if there's anything preventing the blade disc to
®
rotate.
3. Remove any possible obstruction.
4. Turn Minimission upright and take it to an area with short grass or adjust the cutting height.
®
5. Turn power on.
will return to the Charging Base and stay there for the
®
will automatically begin
®
to mow
®
is searching a certain
®
inside
®
5
EN