Neumann MINIMISSION Manual Del Usuario página 8

®
Minimission runs
outside the boundary
®
wire. Minimission does
not mow an area within
a boundary wire zone.
®
Minimission reverses
or rotates erratically near
the boundary wire.
®
Minimission wheels
skid or damage lawn.
®
Minimission exits the
boundary wire due to
high speed when going
down a hill.
8
EN
The boundary wire of another Minimission
another branded robotic mower is positioned too
closely.
The boundary wire has been installed with tight
corners.
In wet conditions, the boundary wire electric
signal may leak were wire has been joined or
repaired.
There is boundary wire electric signal leakage due
to broken insulation.
The cutting area is larger than the allowable cutting
®
area for Minimission .
Foreign obstacles, such as twigs and branches
may be lodged under Minimission
The lawn is too wet.
The Boundary Wire is placed on a slope steeper
than 25%(15°).
®
or Ensure your Minimission
least 0.5 m of spacing between the neighboring
boundary wire.
Check the boundary wire to ensure the corners
are smooth.
Check boundary wire joints. Insulate to provide a
fully waterproof connection.
Repair damaged boundary wire insulation with
insulation tape.
Contact service agent.
Remove foreign objects from underside of
®
. Minimission
Wait until lawn has dried.
Reposition the Boundary Wire away from slopes
that are steeper than 25%(15°). Please refer
installation manual for details.
®
Boundary Wire has at
®
.